Integra DTR-8.3 instruction manual Choosing Another Channel

Using the remote controller with Radio Frequency (USA & Canadian model only)

Changing the Extender ID

1.Make sure the Extender ID button is active.

The button is active when the button label is white.

2.Press the + and – action buttons to change the Extender ID. The remote controller offers 16 Extender ID’s.

5.Tap Accept to save the RF IR settings for the selected device.

or

Tap Cancel to return without changing the RF IR settings for the selected device.

6.Repeat instructions 3 to 5 for all devices for which you want to change the RF IR settings.

7.Tap Close.

The remote controller switches back to Use mode. The remote controller is configured to operate the devices you have set with RF signals.

8.Try the devices of which you just changed the RF IR settings.

Note:

There is a possibility that a device does not respond properly when operated with RF signals. This is mostly due to IR signals that cannot be properly transmitted as RF signals.

In that case, you have to reconfigure the remote controller to operate the device with IR signals again.

Choosing Another Channel

When you notice RF interference, for instance from your neighbors, you have to choose another channel to operate your devices.

Note:

All devices you want to operate with RF signals use the same channel. If you select another channel for one device, the remote controller will automatically change the channel for all devices that work with RF signals.

1.Switch back to RF IR mode.

The Device menu appears.

2.Select a device that is set with RF signals.

The RF IR settings appear.

3.Tap .

The button label turns white indicating that the button is active.

4.Press the + and – action buttons to change the Channel.

The remote controller offers 4 RF Channels.

Note:

The Channel (CH) on the RF Receiver has to match the Channel on the remote controller.

5.Tap Accept to save the selected Channel for all devices that work with RF signals.

or

Tap Cancel to return without changing the Channel.

6.Tap Close.

The remote controller switches back to Use mode. The remote controller is configured to operate the devices you have set with RF signals through the selected Channel.

7.Try all devices which you just changed the Channel.

78