Integra DTR-8.3 Adjusting the brightness of the front display, Temporarily changing the speaker output levels, Using the sleep time (remote controller only)

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the DTR-8.3

using the DIM button on the remote controller or Dimmer button on

the DTR-8.3 front panel.

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the

procedure given below. Each channel can be set between –12 and

+12 decibels (between –15 and +12 decibels for the subwoofer).

Note that the speaker volumes will return to the original settings

when the DTR-8.3 is put in the standby state.

1. Press the CH Sel button and select

the desired speaker.

2. Press the + or – button to adjust the

volume level.

Notes:

•You cannot select a speaker if it is set to “No” or “None” in the

Speaker Config Sub-menu of the Speaker Setup Menu.

•To have your new speaker levels set here overwrite the settings

at Setup Menu → Speaker Setup Menu → Level Calibration

Sub-menu, press the Test button after you complete step 3 in the

procedure above.

Enjoying music or videos with the DTR-8.3

Remote controller

–

VOL

MUTE

CONT

–

LIGHT

Dimmer

Sleep

Dim

CH Sel

+

–

Using the sleep time (remote controller only)

The SLEEP button enables you to set the DTR-8.3 to turn off

automatically after a specified time period. If you press it once, the

DTR-8.3 will turn off after 90 minutes. Each time it is pressed

thereafter, the remaining time until the DTR-8.3 turns off decreases

by 10 minutes (i.e., from 90 to 80 minutes). While, the sleep function

is enabled, you can press the SLEEP button to see how much time is

left. If you now press the SLEEP button, the remaining time will be

reduced down to the nearest 10 minutes. If it is pressed again, then

the remaining time will be decreased by 10 minutes each time it is

pressed (e.g., if SLEEP is pressed with the display reading 54

minutes, it will be reduced to 50 minutes. If it is pressed again, it will

then be reduced to 40, then 30, and so on). If the SLEEP button is

pressed when the time displayed is less than 10 minutes, the sleep

function is cancelled.

If you are using the remote zone (Zone 2), it will turn off at the same

time as the main zone. If you want to set the sleep function for Zone

2 only, set the sleep function with main zone turned on and then put

the main zone into the standby state.

DTR-8.3 Remote controller

Dimmer