Advanced/ZP Technical Product Summary • Page 32
Set Administrative Password
When selected, this brings up a dialog box that allows you to set the Administrative password.
Unattended Start
When selected, this brings up a dialog box that allows you to control when the security password is requested. The
options are Enabled and Disabled. The default is Disabled. The User password must be enabled before you can enable
this option. If Enabled is selected, the system will boot, but the keyboard will be locked until the User password is
entered.
Security Hot Key (CTRL-ALT-)
This allows you to set a hot key that, when pressed, will lock the keyboard until the User password is entered.
EXIT SCREEN
Exit Saving Changes
When selected, this allows you to save the change to CMOS and exit the Setup program. You can also press the <F10>
key anywhere in the Setup program to do this.
Exit Discarding Changes
When selected, this allows you to exit the Setup program without saving any changes. This means that any changes
made while in the Setup program will be discarded and NOT SAVED. Pressing the <Esc> key in any of the four main
screens will do this.
Load Setup Defaults
When selected, this allows you to reset all of the setup options to their defaults. You can also press the <F5> key
anywhere in the Setup program to do this. This selection loads the default values from the ROM table.
Discard Changes
When selected, this allows you to discard any changes you made during the current Setup session without exiting the
program. You can also press the <F6> key anywhere in the Setup program to do this. This selection loads the CMOS
values that were present when the system was turned on.