
Integrated Peripherals
CMOS Setup
Integrated Peripherals
IDE1 Conductor Cable | [Auto] | Item Help | |
IDE2 Conductor Cable | [Auto] | ||
Menu Level X | |||
[Enabled] | |||
[Auto] | |||
[Enabled] | |||
AC97 Audio | [Enabled] | ||
| |||
Onboard LAN device | [Enabled] | [ATA66/100/133] | |
USB Controller | [Enabled] | ||
Set Conductor cable to | |||
USB Legacy Support | [Disabled] | ||
ATA66/100/133 | |||
SiS Serial ATA Controller | [Enabled] | ||
(80 pins) | |||
SiS Serial ATA Mode | [RAID] | ||
| |||
Onboard Serial Port 1 | [3F8/IRQ4] | [ATA33] | |
Onboard Serial Port 2 | [2F8/IRQ3] | ||
Set Conductor cable to | |||
Onboard Parallel Port | [378/IRQ7] | ||
ATA33(40 pins) | |||
Parallel Port Mode | [ECP] |
| |
ECP Mode Use DMA | [3] |
|
KLJI: Move | Enter: Select | F10: Save | ESC: Exit | F1: General Help | |
F5: Previous Values | F6: | F7: Optimized Defaults |
IDE1 Conductor Cable
Auto | BIOS autodetects IDE1 conductor cable .(Default Value) |
ATA66/100/133 | Set IDE1 Conductor Cable to ATA66/100/133 (please make sure your IDE |
| device and cable is compatible with ATA66/100/133). |
ATA33 | Set IDE1 Conductor Cable to ATA33 (please make sure your IDE device and |
| cable is compatible with ATA33). |
IDE2 Conductor Cable
Auto | BIOS autodetects IDE2 conductor cable. (Default Value) |
ATA66/100/133 | Set IDE2 Conductor Cable to ATA66/100/133 (please make sure your IDE |
| device and cable is compatible with ATA66/100/133). |
ATA33 | Set IDE2 Conductor Cable to ATA33 (please make sure your IDE device and |
| cable is compatible with ATA33). |
On-Chip Primary PCI IDE
Enabled | Enable onboard 1st channel IDE port. (Default value) |
Disabled | Disable onboard 1st channel IDE port. |
On-Chip Secondary PCI IDE
Enabled | Enable onboard 2nd channel IDE port. (Default value) |
Disabled | Disable onboard 2nd channel IDE port. |
AC97 Audio
Enabled | Enable onboard AC'97 audio function. (Default value) |
Disabled | Disable this function. |
English
|
|
|
- 27 - | BIOS Setup |