Intel cc2300, cc3300 manual Configuring the Server for LAN Access

Intel Server Control Installation Guide

10.Select “Run System Setup Utility” under the “Utilities” menu. You will see SSU executables installed the first time and then the Server SSU launches.

11.In the Available Tasks list select Platform Event Manager and click OK.

12.Click the Configure EMP button.

13.Enter the following in the Emergency Management Port (EMP) dialog box:

Option	Entry
Enter New Password:	Enter the EMP password (if required), up to 16 characters.
Verify New Password:	Re-enter the EMP password (if required).
ESC Sequence:	+++ (default)
Hangup String:	ATH (default)
Modem Init String:	ATE1Q0V1X4&D0S0=0 (default). May require change based on the installed
	modem requirements.
System Phone Number:	The phone number to call when using a modem to access the EMP port.
Access Mode:	Always Active. (default is Preboot)
Restricted Mode:	Disable. (default is Enable)
Connection Mode:	Modem Connect (default) for modem connections to COM2. Direct Connect
	for serial connections to COM2.

14.Click Save, then Close.

15.Exit from the Server SSU.

16.Quit the menu.

17.Remove the HP Server cc3300 & cc2300 User Information, Diagnostics & Utilities Resource CD from the drive.

18.Reboot the server.

Configuring the Server for LAN Access

To take advantage of LAN access and BMC LAN-Alerts features, server settings must be configured using the Server System Setup Utility (Server SSU). After the settings are initialized they can be changed using the Client System Setup Utility (CSSU). Use the LAN 1 port for server access.

If you are going to define a SNMP community, be sure to do it before installing ISC.

1.Insert the HP Server cc3300 & cc2300 User Information, Diagnostics & Utilities Resource CD into the CD drive.

2.Restart the server.

3.When the “F2 to enter setup” message appears, quickly press F2.

4.In Setup, use the arrow keys to select the Boot menu.

5.Use the arrow keys to select Boot Device Priority then press Enter.

6.Select ATAPI CDROM and use the + key to move the selection to the top of the list.

7.Press F10.

8.Select Yes to confirm saving of the current settings and press Enter. The server restarts and boots from the HP Server cc3300 & cc2300 User Information, Diagnostics & Utilities Resource CD.

9.When the menu appears, use the arrow keys to select the Utilities menu and press Enter.

9