4 ETX® connectors
4.4.2Connector X2 Signal Description
ISA Bus Slot
The implementation of this subsystem complies with the ETX® Specification. Implementation information is provided in the ETX® Design Guide. Refer to the documentation for additional information.
Restrictions:
Memory Transfer:
According to the used LPC 2 ISA solution only memory transfer in the Firmware HUB memory range and with Firmware HUB commands is possible. The Firmware HUB range is from FED4:0000 to FED4:0FFF
I/O Transfer:
Only two generic decoding ranges are available which can be selected in the BIOS setup with a maximum size of 256 Byte. This works of course only, when there are no other devices connected to that I/O ports in that range.
It can be that there is only one decoding range available, when there are the COM and/or parallel ports of an external SuperI/O controller used.
Signal level:
The signal level of the used Fintec controller is 3,3V, 5V tolerant. To achieve the 5V level, most of the signals are pulled up to 5V.
4.5Connector X3 (VGA, LCD, Video, COM1 and COM2, LPT/Floppy, Mouse, Keyboard)
Flat-Panel Interfaces
LVDS Interface Pinout (JILI)
Pin | Signal | Pin | Signal |
1 | GND | 2 | GND |
3 | R | 4 | B |
5 | HSY | 6 | G |
7 | VSY | 8 | DDCK |
9 | DETECT#** | 10 | DDDA |
11 | LCDDO16 | 12 | LCDDO18 |
13 | LCDDO17 | 14 | LCDDO19 |
15 | GND | 16 | GND |
17 | LCDDO13 | 18 | LCDDO15 |
19 | LCDDO12 | 20 | LCDDO14 |
21 | GND | 22 | GND |
23 | LCDDO8 | 24 | LCDDO11 |
|
|
|
|
Kontron User's Guide ETX CD | 26 |
