Intel GA-945PL-DS3P O.C FSB1333 Core 2 CPU, CPU Host Clock Control, CPU Host Frequency Mhz

Full Thrust Set C.I.A.2 to Full Thrust. (Automatically increase CPU frequency(17%, 19%) by CPU loading.

Warning: Stability is highly dependent on system components.

O.C FSB1333 Core 2 CPU

Enable use of a CoreTM 2 CPU with 1333 MHz FSB through overclocking. You must install the FSB 1333 MHz CoreTM 2 CPU with DDRII 533 (or above) memory module(s).

Disabled	Disable this function. (Default value)
Enabled	Enable this function.

CPU Host Clock Control

Please note that if your system is overclocked and cannot restart, please wait 20secs. for automatic system restart or clear the CMOS setup data and perform a safe restart.

Disabled	Disable CPU Host Clock Control. (Default value)
Enabled	Enable CPU Host Clock Control.

CPU Host Frequency (Mhz)

100 ~ 600 Set CPU Host Frequency from 100 MHz to 600 MHz.

If you use a 533 MHz FSB processor, set "CPU Host Frequency" to 133 MHz. If you use a 800 MHz FSB processor, set "CPU Host Frequency" to 200 MHz. If you use a 667 MHz FSB processor, set "CPU Host Frequency" to 266 MHz.

Incorrect using it may cause your system broken. For power End-User use only!

PCI Express Frequency (Mhz)

Auto	Set PCI Express frequency automatically. (Default value)
90~150	Set PCI Express frequency from 90 MHz to 150 MHz.

System Memory Multiplier

The adjustable range will vary based on the CPU FSB. Default value: Auto (set memory frequency by DRAM SPD data). Wrong frequency settings may cause system unable to boot. Clear CMOS to overcome wrong frequency issue.

Memory Frequency (Mhz)

The values depend on CPU Host Frequency (Mhz) and System Memory Multiplier setting.

DIMM OverVoltage Control

Please note that by overclocking your system through the increase of the DIMM voltage, damage to the memory may occur.

Normal	Set DIMM OverVoltage Control to Normal. (Default value)
+0.1V	Set DIMM OverVoltage Control to +0.1V.
+0.2V	Set DIMM OverVoltage Control to +0.2V.
+0.3V	Set DIMM OverVoltage Control to +0.3V.
+0.4V	Set DIMM OverVoltage Control to +0.4V.
+0.5V	Set DIMM OverVoltage Control to +0.5V.
+0.6V	Set DIMM OverVoltage Control to +0.6V.
+0.7V	Set DIMM OverVoltage Control to +0.7V.

Incorrect using it may cause your system broken. For power End-User use only!

English

- 45 - BIOS Setup