Intel GA-N680SLI-DQ6 user manual English

3.Assign Array Disks: After RAID mode is selected, RAID BIOS automatically assigns the two hard disks installed as the RAID disks.

4.Set Block Size (only for RAID 0): Under the Block item, use the UP or DOWN ARROW key to select the block size (Figure 7), ranging from 4K to 128K. Press ENTER when finished.

GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOS V1.06.59

[ Create New RAID ] [ Hard Disk Drive List ]

Name:	GRAID	Mode Name			Available	Type/Status
Level:	0-Stripe	HDD0:	ST3120026AS		120 GB	Non-RAID
Disks:	Select Disk	HDD1:	ST3120026AS		120 GB	Non-RAID
Block:	128 KB
Size:	240 GB
Confirm Creation
[ RAID Disk Drive List ]		[ Help ]
				Setting Stripe Block
		Select a stripe size which will be used to
		divide data from/to seperate RAID members.
		The following are typical values:
				RAID 0-128KB
	[ ]-Switch RAID Block Size	[ENTER]-Next		[ESC]-Abort

Figure 7

5.Set Array Size: Under the Size item, type the size of the array (Figure 8), and press ENTER.

GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOS V1.06.59

[ Create New RAID ]			[ Hard Disk Drive List ]
Name:	GRAID		Mode Name		Available	Type/Status
Level:	0-Stripe		HDD0:	ST3120026AS	120 GB	Non-RAID
Disks:	Select Disk		HDD1:	ST3120026AS	120 GB	Non-RAID
Block:	128 KB
Size:	240 GB
Confirm Creation
[ RAID Disk Drive List ]			[ Help ]
				Setting RAID Capacity
			Enter the RAID capacity. The default value
			indicates the maximum capacity determined
			by the selected members. If less than the
			maximum capacity is chosen, the remaining
			capacity would be no used.
[ ]-Switch Unit		[DEL,BS]-Delete Number		[ENTER]-Next	[ESC]-Abort

Figure 8

English

- 89 - Appendix