Intel GA-N680SLI-DQ6 user manual Configuring RAID array in RAID BIOS, English

(3) Configuring RAID array in RAID BIOS

Enter the RAID BIOS setup utility to configure a RAID array. Skip this step if you do not want to create RAID.

Step 1:

After the POST memory test begins and before the operating system boot begins, look for a message which says "Press <Ctrl-G> to enter RAID Setup Utility" (Figure 3). Press CTRL+ G to enter the GIGABYTE SATA2 RAID BIOS setup utility.

GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOS v1.06.59

Copyright (C) 2005 GIGABYTE Technology.			http://www.gigabyte.com
HDD0	:	ST3120026AS	120 GB	Non-RAID
HDD1	:	ST3120026AS	120 GB	Non-RAID

Press <Ctrl-G> to enter RAID Setup Utility ...

Figure 3

In the main screen of the GIGABYTE SATA2 RAID BIOS utility (Figure 4), use the UP or DOWN ARROW key to highlight through choices. Highlight the item that you wish to execute and press ENTER.

GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOS V1.06.59

[ Main Menu ]	[ Hard Disk Drive List ]
Create RAID Disk Drive	Mode Name	Available	Type/Status
Delete RAID Disk Drive	HDD0: ST3120026AS	120 GB	Non-RAID
Revert HDD to Non-RAID	HDD1: ST3120026AS	120 GB	Non-RAID
Solve Mirror Conflict
Rebuild Mirror Drive
Save And Exit Setup
Exit Without Saving
[ RAID Disk Drive List ]

[ TAB]-Switch Window [ ]-Select ITEM [ENTER]-Action [ESC]-Exit

Figure 4

Note: In the main screen, you can select a hard disk in the Hard Disk Drive List block and press ENTER. This allows you to check detailed information about the selected hard disk.

English

- 87 - Appendix