On-Chip Primary/Secondary PCI IDE:

The integrated peripheral controller contains an IDE interface that supports a single IDE channels. Select Enabled to activate the channel.

USB Keyboard Support:

Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have a USB keyboard. The available choices are Enabled, Disabled.

Init Display First:

This item allows you to decide to active whether PCI Slot or on-chip VGA first The available choices are PCI Slot, Onboard .

KBC Input Clock:

The input clock setting of your onboard keyboard controller is set from here.

Onboard FDC Controller:

Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install and-in FDC or the system has no floppy drive, select Disabled in this field. The available choices are Enabled, Disabled.

Onboard Serial Port 1/2:

This item allows you to determine access onboard serial port 1/2 controller with which I/O address. The available choices are 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.

UART Mode Select:

This option allows you to configure the infrared interface modes (IrDA, ASKIR (an IrDA-compliant serial infrared) port, and Normal) generated from the second serial port. Only when set to ASKIR mode will the options RxD. TxD Active and IR Transmission delay activate for configuration. Disabling the Onboard Serial Port 2 setting automatically removes the UART Mode Select option from the options list.

UART2 Duplex mode:

Select the value required by the IR device connected to the IR port. Full-duplex mode permits simultaneous two-direction transmission. Half-duplex mode permits transmission in one direction only at a time. The available choices are Half, Full.

RxD, TxD Active:

This item allows you to determine the active of RxD, TxD. The available choices are “Hi, Hi”, “Lo, Lo”, “Lo, Hi”, “Hi, Lo”.

51