Intel IQ80333 manual 2.6.4GNUPro GDB/Insight, 2.6.4.1Communicating with RedBoot, Getting Started

Intel® IQ80333 I/O Processor

Getting Started

2.6.4GNUPro GDB/Insight

2.6.4.1Communicating with RedBoot

Hardware Setup:

•Host with UNIX/Linux or Win32 installed

•IQ80333 with serial cable

•RedHat RedBoot monitor Flashed to the platform board

Recommended Mapping of UART Ports to Host Com Ports

•Host port connected to the platform board UART.

The following communication tools can be used:

•Win32 using HyperTerminal

•UNIX using Kermit

•Linux using Minicom

•Solaris using Tip

RedBoot Monitor startup:

Description: terminal emulator runs on host and communicates with the board via the serial cable.

Start:	Power up the IQ80333. While the 'reset' is asserted, the two 7-segment LEDs
	sequentially display “88”, “A0” through “A6”, followed by “SL” (Scrub loop). When
	RedBoot is successfully booted, it displays the characters “A1” on the LEDs. When
	the final state of “A1” does not occur, reset the processor again.

The time for reset is approximately 1 or 2 seconds.

Win32 on Host Connecting with HyperTerminal.

Customer Reference Board Manual 21