Intel PMB-601LF Sata Mode, Super Io Device, Onboard Fdc Controller, ONBOARD SERIAL PORT 1/2, Page

Chapter 4 Award BIOS Setup

4.PRIMARY MASTER/SLAVE UDMA SECONDARY MASTER/SLAVE UDMA

Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver). If you hard drive and your system software both support Ultra DMA/33, select Auto to enable BIOS support.

5.SATA MODE

Set the Serial ATA configuration. When set in Advanced Host Controller Interface (AHCI) or RAID mode, the SATA controller is set to Native mode. Configuration options: [IDE] [RAID] [AHCI]

SUPER IO DEVICE:

The options for these items are found in its sub menu. By pressing the <ENTER> key, you are prompt to enter the sub menu of the detailed options as shown below:

Phoenix – Award CMOS Setup Utility

SuperIO Device

Onboard FDC Controller	[Enabled]		Item Help
Onboard Serial Port 1	[3F8/IRQ4]
Onboard Serial Port 2	[2F8/IRQ3]
UART Mode Select	[Normal]		Menu Level ►
X UR2 Duplex Mode	[Half]
Onboard Parallel Port	[378/IRQ7]
Parallel Port Mode	[SPP]
X ECP Mode Use DMA	3
PWRON After PWR-Fail	[Off]
↑↓→←:Move Enter: Select	+/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values	F6:Fail-Safe Defaults	F7:Optimized Defaults

Descriptions on each item above are as follows:

1.ONBOARD FDC CONTROLLER

Select Enabled if the system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install and-in FDC or the system has no floppy drive, select Disabled.

2.ONBOARD SERIAL PORT 1/2

Select an address and corresponding interrupt for the first and second serial ports.

3.UART MODE SELECT

This item allows you to select UART mode.

Page: 4-16 PMB-601LF USER′S MANUAL