Chapter 4 Award BIOS Setup
4.UR2 DUPLEX MODE
This item allows you to select the IR half/full duplex function.
5.ONBOARD PARALLEL PORT
This item allows you to determine access onboard parallel port controller with which I/O address.
6.PARALLEL PORT MODE
Select an operating mode for the onboard parallel (printer) port. Select Normal, Compatible, or SPP unless you are certain your hardware and software both support one of the other available modes.
7.ECP MODE USE DMA
Select a DMA channel for the parallel port for use during ECP mode.
8.PWRON AFTER PWR-FAIL
This item allows you to select if you want to power on the system after power failure. The
ONBOARD SERIAL PORT 3/4:
SERIAL PORT 3/4 USE IRQ:
Select an address and corresponding interrupt for third and forth serial port.
USB DEVICE SETTING:
The options for these items are found in its sub menu. By pressing the <ENTER> key, you are prompt to enter the sub menu of the detailed options as shown below:
Phoenix – Award CMOS Setup Utility
Onboard Device
USB 1.0 Controller | [Enabled] | Item Help | |
USB 2.0 Controller | [Enabled] | ||
| |||
USB Keyboard Function | [Enabled] |
| |
USB Mouse Function | [Enabled] | Menu Level ► | |
USB Storage Function | [Enabled] | ||
| |||
*** USB Mass Storage Device Boot Setting *** |
| ||
USB Flash Disk 2.00 | [Auto mode] |
| |
|
|
| |
↑↓→←:Move Enter: Select | |||
F5: Previous Values | |||
|
|
|
Descriptions on each item above are as follows:
Page: |