d.When setup is complete a message will pop up indicating that a reboot is necessary and give a choice to “reboot now” or “reboot later”.

e.Remove the CD-ROM from the CD ROM drive and select “reboot now” . The system MUST be rebooted immediately after installation of the RAID Software Suite.

f.Windows 2000 (only): After the system reboots a message will pop up indicating that a new device has been found. Use the “Browse” option point to the <system drive>:\Program Files\RAID Software Suite\Drivers and select the “I2Odisk.inf” file. This will install the device driver for the RAID volume itself. A message will prompt for a reboot. Reboot the system to complete the installation.

✏NOTE

Refer to the user’s manual for information on HP Openview and RAID Monitor, SNMP, DMI components or remote storage console. Also see the user’s manual for instructions on customizing your RAID volumes using Storage Console.

Setup and Installation for Novell† NetWare†

Software Requirements

∙SRCU31L CD-ROM

∙Hard disk space: minimum 4 MB

∙MS-DOS†5.x or later (Novell 4.2 only)

∙SRCU31L NetWare Installation Diskette (one blank high density floppy diskette required)

∙Novell NetWare 4.2 with Service Pack 8a or higher or Novell NetWare 5.0 or 5.1 with Service Pack 4 or higher*

* Not supplied

Installing Novell NetWare on a RAID Volume

There are two procedures listed below (one for each supported version of NetWare). Please follow the instructions for the version you wish to install (version 4.2 or 5.0 and 5.1).

NetWare 4.2

1Create a SRCU31L NetWare Installation Diskette.

a.Insert the Intel Integrated RAID CD-ROM into the target system and restart the system to boot from the CD-ROM.

b.When the ROM-DOS Startup Menu appears select option #1, Make Diskettes.

c.When the Select a diskette to create screen appears, select NetWare Installation. A command window appears.

12

Intel Server RAID Controller U3-1L (SRCU31L)

 

Quick Start Guide