NetWare 5.0 or 5.1

✏NOTE

If you do not use the boot capability of the NetWare 5.0 or 5.1 CD-ROM, then replace step 2-5 below with steps 2-4 of the NetWare 4.2 instructions above.

1Create a SRCU31L NetWare Installation Diskette.

a.Insert the Intel Integrated RAID CD-ROM into the target system and restart the system to boot from the CD-ROM.

b.When the ROM-DOS Startup Menu appears select option #1, Make Diskettes.

c.When the Select a diskette to create screen appears, select NetWare Installation. A command window appears.

d.Insert a blank high-density diskette in drive A: and press Enter to create the SRCU31L NetWare Installation Diskette. Alternatively the CD-ROM can be inserted into a different system running Windows 95, 98 or NT. The CD-ROM’s auto-runfeature will bring up a menu that will allow creation of the SRCU31L NetWare Installation Diskette.

2Insert the NetWare CD-ROM and reboot.

3After booting, accept the license agreement. Then select Create a New Boot Partition.

4When NetWare boots again, it will first format the newly created boot partition, and then begin loading files. During this initialization, you will see a white graphical NetWare logo screen.

5It will eventually load a Welcome screen, asking you to verify the startup directory (C:\NWSERVER). Press Alt F10 to exit the installation. At the console, type Down. The installation exits to the boot drive prompt.

6Insert the SRCU31L NetWare installation diskette created in Step 1 into the A: drive. If your boot drive is C:, then run NWUPDATE.BAT. If your boot drive is other than C:, then create an NWUPDATE subdirectory and copy all the files from A:\DRIVERS into the NWUPDATE subdirectory.

7Remove the diskette from the A: drive and reboot the server. After booting you will be asked to accept the license agreement. Do so and then select Continue with Existing Partition. You are now ready to install NetWare 5 on the Intel Integrated RAID volume.

8Continue with the NetWare installation as normal by following the screen prompts. Select the Block Storage OSM when prompted.

9Reboot the server and install Service Pack 4 or higher. Once the server installation is completed, reboot the server.

10To install the Intel Integrated RAID software (run the Intel Integrated RAID setup) run NWCONFIG.

11Select Product Options, then Install product not listed. It will tell you that it is going to scan the A: drive for installation scripts. Ensure the SRCU31L NetWare Installation diskette is in the floppy drive, press Enter to continue.

14

Intel Server RAID Controller U3-1L (SRCU31L)

 

Quick Start Guide