Intel Server RAID Controller U3-1L Low Profile Hardware Setup
Hardware Requirements
∙Server/Computer with
∙One available PCI slot (32 bit, 33 MHz recommended)
∙Monitor (display resolution of 800 x 600 or higher recommended)
∙Intel Server RAID Controller
Installing Intel Server RAID Controller U3-1L Low Profile into a System
The SRCU31L comes ready to be inserted into the system motherboard. The Intel Integrated RAID firmware has already been programmed into the flash memory.
WARNING
SHOCK HAZARDS may be present inside the unit in which this card is being installed. Disconnect all power cords to the unit before removal of any covers.
Follow the warnings noted in your computers user or service manual before installing this board. ONLY after all the covers are reinstalled should you reattach the power cords and power up the unit for the software installation and use.
1Power down the system, disconnect power cord(s) and remove the system cover.
2Install the SRCU31L into an available PCI slot. Connect one end of the SCSI cable to the internal (68 pin) or external (VHDCI) SCSI connector on the SRCU31L. Connect the other end of the SCSI cable to the SCSI drives or drive enclosure.
3Replace the system cover, reconnect power cord(s).
✏NOTE
SRCU31L will work in a 64 bit slot, however, a 32 bit, 33 MHz PCI slot is recommended. Consult the system guide for the target server board to determine an appropriate 32 bit, 33 MHz PCI slot.
✏NOTE
Ensure that the end of the SCSI bus is properly terminated. Consult the documentation for the drives or drive enclosure for termination details.
Intel Server RAID Controller | 7 |
Quick Start Guide |
|