Intermec PF8T, PF8D manual Understanding Auto-Sensing Mode, To use Auto-Sensing mode

Chapter 2 — Installing the Printer

Compact flash card slot cover

5Insert the compact flash card in the compact flash adapter. Make sure that the card is oriented correctly to fit in the slot. Push firmly to seat the card.

6Install the compact flash card slot cover.

7Close the top cover and turn on the printer power.

Understanding Auto-Sensing Mode

The Auto-Sensing mode can be used for the following:

•Adjusting the label gap sensor

•Printing a test label with a test pattern and list of the printer’s current settings

•Entering Dump mode

To use Auto-Sensing mode

1Load media in the printer.

2Press and hold the Feed button while turning the Power switch to the On position (⎯).

The status LED blinks green for 2 seconds, blinks red for 2 seconds, and then blinks green again.

Note: If you are using continuous stock or gap media, release the Feed button when the status LED is blinking green. If you are using black marked media, release the Feed button when the LED is blinking red.

PF8d/PF8t Printers User’s Guide 17