Intex Recreation HT30220 manual SET-UP Instructions, SET UP Instructions

SET-UP INSTRUCTIONS

(114) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.5” PANTONE 295U 12/18/2006

114

SET UP INSTRUCTIONS

IMPORTANT: The electrical pool heater must be installed as the last piece of pool equipment before the saltwater pool or chlorine generator system in the water return line to the pool

1.Assemble the above-ground-pool (AGP) and its filter pump per installation instructions.

2.Remove the electrical pool heater and it’s accessories from the packaging.

3.Place the electrical pool heater in line after the filter pump.

4.Connect the hose (1) to the electrical pool heater inlet. (See following page)

5.If your above-ground-pool is filled up with water, unscrew the strainer grids from the strainer connectors and insert the black hat-like plugs into the strainer connectors before electrical pool heater installation. Go to step 6 directly if your pool is empty.

6.Disconnect the water return (to the pool) hose from the filter pump connection, and connect it to the upper electric pool heater connection with a hose clamp.

7.Connect the second hose to the lower electric pool heater connection and to the lower pump connection. Make sure all the hose clamps (2) are tight.

8.If applicable, return strainer grids to strainer connectors inside pool after removing black hat-like plugs that prevented water from flowing out of the pool.

9.Connect the electric pool heater to the power outlet. Test RCD as shown on following page.

10.Turn pump on. Check water is flowing through the heater. Then turn heater on.

IMPORTANT

If the heater is not in an upright position a safety switch will automatically turn the heater off. Be sure the heater is always in an upright position while the cord is connected to the power outlet.

SAVE THESE INSTRUCTIONS

Page 5