IntraServer Technology ITIpci 5100G/GF Configuring the Host Files

#sync

#sync

#halt

Then, at the ok prompt, use the following command to list the system devices:

ok show-devs

ITI-5100G/GF adapter output will be displayed. Sample PCI examples are shown on the next page.

For PCI systems, " ethernet@1 " identifies the PCI ITI-5100G/GF adapter:

/SUNW,ffb@1e,0 /SUNW,UltraSPARC-II@0,0 /pci@1f,2000 /pci@1f,4000 /counter-timer@1f,1c00 /virtual-memory /memory@0,60000000 /aliases

/options

/openprom

/chosen

/packages

/pci@1f,2000/ethernet@1

/pci@1f,4000/scsi@3

/pci@1f,4000/network@1,1

/pci@1f,4000/ebus@1

/pci@1f,4000/scsi@3/tape

/pci@1f,4000/scsi@3/disk

/pci@1f,4000/ebus@1/SUNW,CS4231@14,200000

....

If the appropriate ITI-5100G/GF device is not listed, check that the adapter is installed and properly seated. Then restart the system and re-install the adapter software.

Configuring the Host Files

Once the ITI-5100G/GF adapter software is installed on your system, it must be configured. To ensure proper adapter performance, configure the host files and driver parameters as described in the following sections.

LSI Logic Corporation Page 25 of 56