NOTE: When properly installed, the tube edge will rest inside the top edge of the new glide tip. If the tube edge is visible, the tip is not properly installed.
3.Insert the new glide tip firmly into the leg extension.
4.Ensure the new glide tip is properly installed as shown in Detail ʺAʺ of FIGURE 3. If necessary, tap new glide tip into position.
5.Press the snap button and install the leg extension with new glide tip onto the walker frame leg. Ensure that the snap button of each leg fully protrudes through the desired adjustment hole and legs are adjusted so the walker sits level.
6.Repeat STEPS 1‐5 on remaining rear leg extension.
Snap
Button
Walker
Frame Leg
Leg Tube
Glide Tip
DETAIL “A”
Glide Tip | Glide Tip |
Improperly Installed | Properly Installed |
FIGURE 3 Installing the Glide Tip
Replacing Fixed Wheels/Swivel Casters
NOTE: For this procedure, refer to FIGURE 4 on page 6.
NOTE: Refer to Installation Warning on page 2.
Fixed Wheels - Model Nos. 6270 and 6271
1.Position one wrench on the hex screw and remove the locknut by using the other wrench and turning counterclockwise.
2.Remove the washers, wheel, bushing and hex screw that secure the wheel to the leg extension.
3.Inspect washers, bushing and hex screw for wear and/or damage and replace if necessary.
4.To install new wheel, reverse STEPS 1‐2.
Swivel Casters - Model Nos. 6273 and 6267
1.Grip leg tube and using the crescent wrench, apply to hex nut.
2.Loosen swivel caster and unscrew from swivel caster housing.
3.Inspect swivel caster housing and leg tube for any damage. If damaged, replace immediately.
4.Insert new swivel caster by screwing it into swivel caster housing and tightening with the crescent wrench.
Part No 1118382 | 5 | Leg Extensions and |
|
| Wheeled Walker Accessories |
