The Invacare® Auriga/Auriga10 is equipped with an integrated charger. The socket for this charger is located on the front of the Battery and Motor Compartment Cover (1). To charge the scooter, you only need to connect it to a mains power supply using the cable supplied with the scooter.

Connecting the scooter to a mains power supply

First connect the cable to the scooter.

Then connect the cable to the mains power supply and switch on.

Disconnecting the scooter from the mains power supply

First disconnect the cable from the mains power supply.

Then disconnect the cable from the scooter.

How can I tell when the batteries are fully charged?

Look through the slot for the de-clutching lever (2) down into the motor and battery compartment. You will see a green LED. This is the charger LED.

LED ACTIVITY

CHARGING PHASE

LED lights contantly

Start

LED dims and flickers

90% Finished

LED go out / flickers for a few seconds /

Finished

goes out again

 

43

Page 43
Image 43
Invacare Auriga10 Connecting the scooter to a mains power supply, Disconnecting the scooter from the mains power supply