Removing the batteries Requirements | Invacare Auriga10 instruction

8.2.3.1Removing the batteries

Requirements:

•Wrench 11 mm

•Remove the seat.

•Remove the battery and motor compartment cover.

•Disconnect the main cable harness.

•Open the belts that hold the batteries in place (1).

•Loosen battery clamp of the blue cable at the negative pole of the battery with the wrench and remove cable.

•Loosen the battery clamp of the red cable at the positive pole of the battery with the wrench and remove cable.

•Repeat procedure on the other side.

NOTE

Fitting of new batteries is done in reverse order.

46

Image 46

Invacare Auriga10 user manual Removing the batteries Requirements

Contents

Auriga10 How can you get in touch with Invacare? Deutschland Danmark Portugal Table of Contents Adjusting the position of the seat from front to back Adjustment OptionsCare and maintenance Repair Instructions Electrical System Removing a front wheel 3-Wheel Version Technical Specifications Inspections PerformedDismantling the scooter for transport 11.1 Introduction Dear userPage This symbol warns you of danger Important symbols in this manualRequirements Type Classification and Area of Use Safety Notes General Safety NotesPage Page Safety information with regard to care and maintenance Safety Information on Electromagnetic Interference Safety Information on Driving and Freewheel Mode Page Key features Driving Before driving for the first time Driving down off of an obstacle Taking ObstaclesDriving up over an obstacle Correct Incorrect Driving up and down gradients Activating the brake Parking and stationaryActivating and de-activating the parking brake option Releasing the brake Disengaging Motors Pushing the scooter by handEngaging the motor Control Panel Control Panel layout Seat Lifter Button Status display Battery charge display Driving the Scooter Diagnostics and Trouble Shooting Contact your authorised Invacare Dealer Diagnosing FaultsCount the number of flashes and refer to the next section Error Codes and Diagnostic Codes Number Fault Impact on Flashes Scooter Number Fault Impact on Flashes Scooter Contact your authorised Invacare Dealer Adjustment Options Adjusting the angle of the backrest Adjusting the position of the seat from front to back Adjusting the width of the armrests Releasing the seat so that it may rotated and/or removed Adjusting the height of the seat Page Electrical System Electronics Protection System Main fuse BatteriesWhat you need to know about batteries Page Charging the batteries Disconnecting the scooter from the mains power supply Connecting the scooter to a mains power supplyHow can I tell when the batteries are fully charged? Connecting the charger Disconnecting the charger After contact with skin Removing and fitting batteriesAfter contact with eyes Removing the batteries Requirements Disposing of dead or damaged batteries correctly Care and maintenance Cleaning the vehicle Seat and backrest padding Maintenance JobsCleaning Tyres Repairing a flat tyre Repair Instructions Removing a rear wheel Requirements Repairing a flat tyre pneumatic tyres type 260 xRe-assembly Having trouble removing the wheel? Removing a front wheel 4-Wheel Version Requirements Removing a front wheel 3-Wheel Version Requirements Repairing the flat tyre Requirements General Requirements 3-Wheel Version front wheel Did the old inner tube get wet during repair? Dismantling the scooter for transport Removing the seat Removing the batteries and the Drive Unit Removing the batteries Removing the Drive Unit Weight Technical SpecificationsElectrical System Dimensions Driving attributes Range according to ISO 7176 Inspections Performed English