Batteries, Main fuse | Invacare Auriga10 manual

8.1.1The main fuse

The entire electric system is protected against overload by two master fuses. The master fuses are mounted on the positive battery cables.

NOTE

A defective main fuse may be replaced only after checking the entire electric system. An Invacare® specialised dealer must perform the replacement.

8.2Batteries

8.2.1What you need to know about batteries

Power is supplied by two 12V gel batteries. The batteries are maintenance-free and only need regular charging.

New batteries should always be fully charged once before their first use. New batteries will be at their full capacity after having run through approx. 10 - 20 charging cycles. How fast the batteries will be discharged will depend on many circumstances, such as ambient temperature, condition of the surface of the road, tyre pressure, weight of the driver, way of driving and utilisation of lighting, etc.

40

Image 40

Invacare Auriga10 user manual Batteries, Main fuse, What you need to know about batteries

Contents

Auriga10 How can you get in touch with Invacare? Deutschland Danmark Portugal Table of Contents Adjustment Options Care and maintenance Repair InstructionsAdjusting the position of the seat from front to back Electrical System Technical Specifications Inspections Performed Dismantling the scooter for transportRemoving a front wheel 3-Wheel Version 11.1 Introduction Dear userPage This symbol warns you of danger Important symbols in this manualRequirements Type Classification and Area of Use Safety Notes General Safety NotesPage Page Safety information with regard to care and maintenance Safety Information on Electromagnetic Interference Safety Information on Driving and Freewheel Mode Page Key features Driving Before driving for the first time Taking Obstacles Driving up over an obstacle CorrectDriving down off of an obstacle Incorrect Driving up and down gradients Parking and stationary Activating and de-activating the parking brake optionActivating the brake Releasing the brake Disengaging Motors Pushing the scooter by handEngaging the motor Control Panel Control Panel layout Seat Lifter Button Status display Battery charge display Driving the Scooter Diagnostics and Trouble Shooting Contact your authorised Invacare Dealer Diagnosing FaultsCount the number of flashes and refer to the next section Error Codes and Diagnostic Codes Number Fault Impact on Flashes Scooter Number Fault Impact on Flashes Scooter Contact your authorised Invacare Dealer Adjustment Options Adjusting the angle of the backrest Adjusting the position of the seat from front to back Adjusting the width of the armrests Releasing the seat so that it may rotated and/or removed Adjusting the height of the seat Page Electrical System Electronics Protection System Main fuse BatteriesWhat you need to know about batteries Page Charging the batteries Disconnecting the scooter from the mains power supply Connecting the scooter to a mains power supplyHow can I tell when the batteries are fully charged? Connecting the charger Disconnecting the charger After contact with skin Removing and fitting batteriesAfter contact with eyes Removing the batteries Requirements Disposing of dead or damaged batteries correctly Care and maintenance Cleaning the vehicle Maintenance Jobs CleaningSeat and backrest padding Tyres Repairing a flat tyre Repair Instructions Repairing a flat tyre pneumatic tyres type 260 x Re-assemblyRemoving a rear wheel Requirements Having trouble removing the wheel? Removing a front wheel 4-Wheel Version Requirements Removing a front wheel 3-Wheel Version Requirements Repairing the flat tyre Requirements General Requirements 3-Wheel Version front wheel Did the old inner tube get wet during repair? Dismantling the scooter for transport Removing the seat Removing the batteries and the Drive Unit Removing the batteries Removing the Drive Unit Weight Technical SpecificationsElectrical System Dimensions Driving attributes Range according to ISO 7176 Inspections Performed English