Invacare KSS Quick Release Clamps For Seat Figure, Twist Release Clamps For Back Figure

Locking Mechanism

Twist Release

Cane Clamp

Socket Screw

Inside

Back Cane Back Mounting

Hook

Seat Rail

NOTE: For TRANSPORT READY OPTION (TRRO) Twist Release Cane Clamp is REVERSED.

FIGURE 11- TWIST RELEASE CLAMPS FOR BACK

8.Once twist release mounting clamps are secured, do one (1) of following:

A.Refer to QUICK RELEASE CLAMPS FOR SEAT in PROCEDURE 1 of this instruction sheet.

B.Refer to USING CLAMPS in this instruction sheet.

Quick Release Clamps For Seat (FIGURE 12)

NOTE: Refer to INSTALLATION WARNING in the

SAFETY SUMMARY before proceeding.

NOTE: The quick release clamps are designed to fit either 1-inch rail tubing or, with insert provided, 7/8-inch rail tubing.

1.Remove the sleeve, lock washer, and internal threaded mounting screw from the quick release clamp (DETAIL “A”) .

2.Place the quick release clamp on the seat rail.

3.If quick release clamp is not tightly fitted around seat rail tubing, install insert provided as shown in DE- TAIL “A” .

4.Install the quick release clamp onto the seat rail so that the fixed portion is flush against and rests on top of the mounting hook and the release portion is be- tween the front riggings and the mounting hook.

5.Reinstall the sleeve, lock washer, and internal mount- ing screw into the quick release rail clamp and torque to 75 - inch pounds.

6.Repeat STEPS 1- 5 for other side.

7.Once quick release mounting clamps are secured, do one (1) of following:

A.Refer to TWIST RELEASE CLAMPS FOR BACK in PROCEDURE 1 of this instruction sheet.

B.Refer to USING CLAMPS in this instruction sheet.

	Insert	DETAIL		“A”
Lock Washer
			Internal
	Sleeve
			Mounting
			Screw
Back Cane
	Fixed		Release
Portion
			Portion

Mounting Hook

Quick Release

Rail Clamp

FIGURE 12- QUICK RELEASE CLAMPS FOR SEAT

PROCEDURE 2 - INSTALLING CLAMPS ON SEATING SYSTEMS WITHOUT A GROWTH BRACKET

Twist Release Clamps For Back (FIGURE 11)

NOTE: Refer to INSTALLATION WARNING in the SAFETY SUMMARY before proceeding.

1.Make sure that the back mounting hooks are flush against the back canes.

2.Loosen the socket screw that opens the twist re- lease clamp.

NOTE: There is a right and left twist release clamp. Make sure when installing that the socket screw adjustment is on the outside of the wheelchair frame.

3.Install the open end of the twist release clamp below the back mounting hook so that the locking mecha- nism rests on top of the mounting hook.

4.Loosely tighten the socket screw.

5.Repeat STEPS 1- 4 for the other side.

6.Make sure both twist release clamps are flush against the back mounting hooks and that the locking mecha- nism rests on top of the back mounting hooks.

10