Invacare KSS Adjusting the Angle of the Back Figure, Attaching, Standard Adjustments

2.Loosen the two (2) mounting screws that secure the growth bracket to the back.

3.Adjust the back up or down until the desired mount- ing position is obtained.

4.Securely tighten the two (2) mounting screws.

5.If more adjustment is needed, the adjustment screws can be completely removed, and the bracket set to a NEW T-nutted hole location. Refer to the ATTACHMENT POINTS in this instruction sheet for optional attachment points.

6.Zip center panel of back cover closed.

ADJUSTING THE ULTI-MATE BASE DEPTH.

1.If necessary, unzip center panel of the back cover.

2.Loosen the four (4) mounting screws that secure the growth bracket to the Ulti-Mate Base.

3.Adjust the seat forward or back until the desired mounting position is obtained.

4.Securely tighten the two (2) mounting screws.

5.If more adjustment is needed, the adjustment screws can be completely removed, and the bracket set to a NEW T-nutted hole location. Refer to the ATTACHMENT POINTS in this instruction sheet for optional attachment points.

6.Zip center panel of back cover closed.

Top Mounting

Screws

Bottom Mounting

Screws

FIGURE 2 - ATTACHING / ADJUSTING THE ADJUSTABLE ANGLE GRO WTH BRACKET

ADJUSTING THE ANGLE OF THE BACK (FIGURE 3)

NOTE: The adjustable angle growth bracket is infinitely angle adjustable. The back-to-seat angle is set by the location of the mounting points for the back in relation to the base and by changing the hole positions of the ad- justable angle back hooks.

1.Remove the two (2) attaching screws and nuts on the adjustable angle back hooks.

2.Recline the back to the desired angle.

3.Align one (1) round hole and one (1) slotted hole on the back L-bracket with two (2) of the holes on the hook portion.

4.Reinstall the two (2) screws and nuts and securely tighten.

Hook Portion

Nuts

L-Bracket

Attaching Screws

FIGURE 3 - ADJUSTING THE ANGLE OF THE BACK

ATTACHING/ADJUSTING THE LATERAL SUPPORTS (FIGURE 4)

Attaching

1.Remove lateral support and mounting hardware from packaging.

2.Feed lateral support bracket through the slots pro- vided in the back cover.

3.Attach lateral support bracket to back shell as shown in FIGURE 2 with the two (2) mounting screws pro- vided. Repeat for opposite side.

4.If adjustment is required, refer to ADJUSTING THE LATERAL SUPPORTS in this instruction sheet. If so equipped continue with USING THE SWING-

AWAY LATERAL SUPPORTS.

Adjusting

NOTE: Lateral supports provide adjustment up to 2- inches for height; 2-inches for width, and 1-inch for depth.

STANDARD ADJUSTMENTS.

NOTE: There are additional mounting holes located on the back shell to provide width and height adjustment for a more comfortable fit. Only the child/junior size is shown for clarity. Refer to the ATTACHMENT POINTS chart in this instruction sheet for standard and optional attach- ment points.

3