7. | Torque socket screw to 75 - inch pounds. |
8. | Once twist release mounting clamps are secured, |
| do one (1) of following: |
| A. Refer to FIXED RELEASE CLAMPS FOR |
DETAIL “B”
Sleeve
Lock
Washer
Mounting
BACK in PROCEDURE 2 of this instruction |
sheet. |
B. Refer to USING CLAMPS in this instruction |
Hook
Back Cane
Fixed
Portion
sheet. |
Fixed Release Clamps For Back (FIGURE 13)
NOTE: Refer to INSTALLATION WARNING in the
SAFETY SUMMARY before proceeding.
NOTE: The fixed release rail/cane clamps are designed to fit either
1.Remove the mounting screw, lock washer, and internal threaded mounting screw from the fixed release clamps (DETAIL “B”) .
2.Place the fixed release clamp on the back cane.
3.If fixed release clamp is not tightly fitted around back cane tubing, install insert provided as shown in DE- TAIL “A” .
4.Install the fixed release clamp onto the back rail so that the fixed portion is flush against and rests on top of the mounting hook and is located between the seat rail and the bottom of the mounting hook.
5.Reinstall the mounting screw, lock washer, and internal mounting screw into the fixed release rail/ cane clamp and torque to 75 - inch pounds.
6.Repeat STEPS 1 - 5 for other side.
7.Once fixed release mounting clamps are secured, do one (1) of following:
A.Refer to QUICK RELEASE CLAMPS FOR SEAT in PROCEDURE 2 of this instruction sheet.
B.RefertoUSING CLAMPS inthisinstructionsheet.
Twist Release
MountingClamp
Hooks
Inside of Back Cane
Fixed Release
Clamp
Seat Rail
FIGURE 13- FIXED RELEASE CLAMPS FOR BACK
Internal Mounting
Screw
FIGURE 13- FIXED RELEASE CLAMPS FOR BACK
Quick Release Clamps For Seat (FIGURE 14)
NOTE: Refer to INSTALLATION WARNING in the SAFETY SUMMARY before proceeding.
NOTE: The quick release and fixed release clamps are designed to fit either
1.Remove the sleeve, lock washer, and internal threaded mounting screw from the quick release clamp (DE- TAIL “C”) .
2.Place the quick release clamp on the seat rail.
3.If quick release clamp is not tightly fitted around seat rail tubing, install insert provided as shown in DE- TAIL “C” .
4.Install the quick release clamp onto the seat rail so that the fixed portion is flush against and rests on top of the mounting hook and the release portion is be- tween the front riggings and the mounting hook.
5.Reinstall the sleeve, lock washer, and internal mount- ing screw into the quick release clamp and torque to 75 - inch pounds.
6.Repeat STEPS 1- 5 for other side.
7.Once quick release mounting clamps are secured, do one (1) of following:
A.Refer to FIXED RELEASE CLAMPS FOR SEAT in PROCEDURE 2 of this instruction sheet.
B.Refer to USING CLAMPS in this instruction sheet.
11
