SECTION 8—BACK

SECTION 8—BACK

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

Adjusting the Back Height

NOTE: For this procedure, refer to FIGURE 8.1.

NOTE: Back canes must be adjusted to the same height.

1.R32 Model ONLY: Remove the two (2) bottom back upholstery mounting screws securing the back upholstery to the wheelchair frame.

2.Remove the two (2) mounting screws and locknuts that secure the two (2) back canes to the back cane mounting tube.

3.Reposition the back canes to the desired height adjustment position.

4.Reinstall the mounting screws and locknuts that secure the back canes to the wheelchair frame and securely tighten.

5.Reinstall the two (2) bottom back upholstery mounting screws securing the back upholstery to the wheelchair frame.

Back

Back Cane

Upholstery

Wheelchair

 

 

Frame

Upholstery

Mounting Screw

Locknut

Mounting

Screw

Back Height (in inches)

* HOLE #

1

2

3

 

 

 

 

HEIGHT

16

17

18

 

 

 

 

*NOTE: Holes numbered from bottom to top for reference only. There are no numbers on the back canes or wheelchair frame.

FIGURE 8.1 Adjusting the Back Height

Nutron® Series

40

Part No.1106644

Page 40
Image 40
Invacare Nutron Series manual Adjusting the Back Height