Manuals / Brands / Personal Care / Mobility Aid / Invacare / Personal Care / Mobility Aid

Invacare ProntoTM M6 WARNING/CAUTION LABEL LOCATION - PRONTO M6

1 48

Download 48 pages, 1.1 Mb

WARNING/CAUTION LABEL LOCATION - PRONTO™ M6 G

GENERAL GUIDELINES PROCEDURE 1

! WARNING

Positioning joystick PARALLEL to armrest allows wheelchair to be SLOWLY

maneuvered up to a desk/table. ANY other wheelchair operation is to be

performed with joystick secured with retaining pin in FRONTAL position -

otherwise injury or damage may result. Rev. A (1)-05/00 P/N 1098340

NOTE: Warning label 1098342 is located UNDER

the shroud.

Contents

Main WARNING SPECIAL NOTES TABLE OF CONTENTS SPECIFICATIONS GENERAL WARNINGS Page GENERAL WARNINGS (CONTINUED) SAFETY/HANDLING OF WHEELCHAIRS WARNINGS ESCALATORS? SORRY! Page WARNING/CAUTION LABEL LOCATION - PRONTO M6 ! WARNING NOTE: Warning label 1098342 is located UNDER the shroud. SAFETY INSPECTION CHECKLIST This Procedure Includes the Following: Safety Inspection Checklist Troubleshooting Guide SAFETY INSPECTION/TROUBLESHOOTINGPROCEDURE 2 TROUBLESHOOTING GUIDE SAFETY INSPECTION/TROUBLESHOOTING PROCEDURE 2 WHEELCHAIR OPERATION Page ARMREST ANGLE ADJUSTMENT (FIGURE 1) M ARMSPROCEDURE 4 ARMREST WIDTH ADJUSTMENT (FIGURE 2) ARMREST DEPTH ADJUSTMENT ARMREST HEIGHT ADJUSTMENT (FIGURE 4) M ARMS PROCEDURE 4 REMOVING/INSTALLING SEAT SUPPORT COLLARS (FIGURE 1) SEAT ASSEMBLY Page ADJUSTING THE SEAT HEIGHT NOTE: The seat can be adjusted to three (3) height positions. NOTE: When installing the retaining pins, it neces- sary to support the weight of the seat assembly. Page ADJUSTING THE SEAT SUPPORT POSTS (FIGURE 6) ADJUSTING THE SEAT DEPTH (FIGURE 7 AND 8) SEAT POSITIONING STRAP (FIGURE 9) C K BACKPROCEDURE 6 FOLDING/UNFOLDING THE BACK (FIGURE 1) ADJUSTING THE BACK ANGLE (FIGURE 2) ADJUSTING THE HEADREST REMOVING/INSTALLING/ ADJUSTING THE FOOTBOARD ASSEMBLY (FIGURE 1) ADJUSTING THE FOOTBOARD ASSEMBLY ANGLE (FIGURE 3) SHROUD/WHEELS PROCEDURE 8 REPLACING THE FOAM FILLED TIRES ONTO THE WHEEL RIM SHROUD (FIGURE 1) U D / L ENGAGING/DISENGAGING MOTOR LOCKS (FIGURE 2) Page REPLACING THE FRONT/REAR CASTER ASSEMBLIES (FIGURE 4) REMOVING/INSTALLING THE AXLE SHROUD COVERS (FIGURE 3) SHROUD/WHEELS PROCEDURE 8 U D / L REMOVING/INSTALLING BATTERIES WITHOUT REMOVING CABLES (FIGURE 1) CONNECTING/DISCONNECTING BATTERY CABLES (FIGURE 2) BATTERIES PROCEDURE 9 CONNECTING/DISCONNECTING CIRCUIT BREAKER CABLES REPLACING BATTERIES BATTERIES PROCEDURE 9 NOTE: Invacare recommends that both batteries be replaced if one (1) battery is defective. NOTE: The recommended battery type is U1 deep cycle. NOTE: When done, these areas should be shiny, not dull. WHEN TO CHARGE BATTERIES (FIGURE 4) NOTE: Accurate readings are displayed when in neu- tral. Battery Discharge Indicator (BDI) CHARGING BATTERIES PROCEDURE 9 BATTERIES BATTERY CHARGER OPERATION REMOVING/INSTALLING ON- BOARD BATTERY CHARGER RETRACTING THE MKIV JOYSTICK (FIGURE 1) DISCONNECTING/CONNECTING THE MKIV JOYSTICK (FIGURE 2) REPOSITIONING THE MKIV JOYSTICK P TRANSPORTPROCEDURE 11 TRANSPORTING THE WHEELCHAIR (FIGURES 1 AND 2) Page SAFETY FLAG (FIGURE 2) CRUTCH/CANE HOLDER (FIGURE 1) OPTIONSPROCEDURE 12 P Page NOTES LIMITED WARRANTY WARRANTY Y