Invacare ProntoTM M6 manual Transporting the Wheelchair Figures 1, Disassembling The Wheelchair

PROCEDURE 11 TRANSPORT

This Procedure Includes the Following:

Transporting the Wheelchair

T WARNING

RAfterANYadjustments,repairorserviceandBE-

AFORE use, make sure that all attaching hard- ware is tightened securely - otherwise injury or

N	damage may result.
S

PFor the following procedures, make sure the

OON/OFF switch on the joystick is in the OFF position.

R

TTRANSPORTING THE WHEELCHAIR (FIGURES 1 AND 2)

Disassembling The Wheelchair

NOTE: To reassemble the wheelchair, reverse the following steps.

1.Disconnect the joystick. Refer to DISCON-

NECTING/CONNECTING THE MKIV JOY- STICK in PROCEDURE 9 of the manual.

2.Fold down the back. Refer to FOLDING/UN- FOLDING THE BACK in PROCEDURE 5 of the manual.

3.Remove the seat. Refer to REMOVING/IN- STALLING THE SEAT in PROCEDURE 4 of the manual.

4.Remove the shroud. Refer to REMOVING/ INSTALLING THE SHROUD in PROCE- DURE 7 of the manual.

NOTE: The motor connectors are located UN- DERNEATH the FRONT frame assembly.

WARNING

When reconnecting the motors, be sure the motor wires are routed toward the INSIDE of the wheelchair frame - otherwise, injury or damage may result.

5.Disconnect the LEFT motor connector from the controller connector.

6.Repeat STEP 5 for the RIGHT motor connector.

STEP 5 AND 6 Controller	STEP 7
Connector Battery	Controller
Connector	Connector STEP 8
Left Motor	Circuit Breaker
Connector

Left Motor Wire

Routed (Toward

Inside Of Frame)

Wheelchair Frame	Front Frame
	Assembly
STEP 9 AND 10	Red	Black
Retaining
	Cable	Cable
Pin

Rear

Frame

Assembly

	DETAIL "A"
Retaining	Bend
Pin Lock	Lock
	Out

FIGURE 1 - TRANSPORTING THE WHEELCHAIR

42