Invacare ProntoTM M6

Invacare Corporation www.invacare.com

USA Canada

One Invacare Way 5970 Chedworth Way Invacare and "Yes, you can" are trademarks of Invacare

Elyria, Ohio USA Mississauga, Ontario Corporation

44036-2125 L5R 3T9, Canada 2000 Invacare Corporation

800-333-6900 905-890-8838 Form No. 99-249 Part No. 1098184 Rev B (2) - 10/00

Contents

Main WARNING SPECIAL NOTES TABLE OF CONTENTS SPECIFICATIONS GENERAL WARNINGS Page GENERAL WARNINGS (CONTINUED) SAFETY/HANDLING OF WHEELCHAIRS WARNINGS ESCALATORS? SORRY! Page WARNING/CAUTION LABEL LOCATION - PRONTO M6 ! WARNING NOTE: Warning label 1098342 is located UNDER the shroud. SAFETY INSPECTION CHECKLIST This Procedure Includes the Following: Safety Inspection Checklist Troubleshooting Guide SAFETY INSPECTION/TROUBLESHOOTINGPROCEDURE 2 TROUBLESHOOTING GUIDE SAFETY INSPECTION/TROUBLESHOOTING PROCEDURE 2 WHEELCHAIR OPERATION Page ARMREST ANGLE ADJUSTMENT (FIGURE 1) M ARMSPROCEDURE 4 ARMREST WIDTH ADJUSTMENT (FIGURE 2) ARMREST DEPTH ADJUSTMENT ARMREST HEIGHT ADJUSTMENT (FIGURE 4) M ARMS PROCEDURE 4 REMOVING/INSTALLING SEAT SUPPORT COLLARS (FIGURE 1) SEAT ASSEMBLY Page ADJUSTING THE SEAT HEIGHT NOTE: The seat can be adjusted to three (3) height positions. NOTE: When installing the retaining pins, it neces- sary to support the weight of the seat assembly. Page ADJUSTING THE SEAT SUPPORT POSTS (FIGURE 6) ADJUSTING THE SEAT DEPTH (FIGURE 7 AND 8) SEAT POSITIONING STRAP (FIGURE 9) C K BACKPROCEDURE 6 FOLDING/UNFOLDING THE BACK (FIGURE 1) ADJUSTING THE BACK ANGLE (FIGURE 2) ADJUSTING THE HEADREST REMOVING/INSTALLING/ ADJUSTING THE FOOTBOARD ASSEMBLY (FIGURE 1) ADJUSTING THE FOOTBOARD ASSEMBLY ANGLE (FIGURE 3) SHROUD/WHEELS PROCEDURE 8 REPLACING THE FOAM FILLED TIRES ONTO THE WHEEL RIM SHROUD (FIGURE 1) U D / L ENGAGING/DISENGAGING MOTOR LOCKS (FIGURE 2) Page REPLACING THE FRONT/REAR CASTER ASSEMBLIES (FIGURE 4) REMOVING/INSTALLING THE AXLE SHROUD COVERS (FIGURE 3) SHROUD/WHEELS PROCEDURE 8 U D / L REMOVING/INSTALLING BATTERIES WITHOUT REMOVING CABLES (FIGURE 1) CONNECTING/DISCONNECTING BATTERY CABLES (FIGURE 2) BATTERIES PROCEDURE 9 CONNECTING/DISCONNECTING CIRCUIT BREAKER CABLES REPLACING BATTERIES BATTERIES PROCEDURE 9 NOTE: Invacare recommends that both batteries be replaced if one (1) battery is defective. NOTE: The recommended battery type is U1 deep cycle. NOTE: When done, these areas should be shiny, not dull. WHEN TO CHARGE BATTERIES (FIGURE 4) NOTE: Accurate readings are displayed when in neu- tral. Battery Discharge Indicator (BDI) CHARGING BATTERIES PROCEDURE 9 BATTERIES BATTERY CHARGER OPERATION REMOVING/INSTALLING ON- BOARD BATTERY CHARGER RETRACTING THE MKIV JOYSTICK (FIGURE 1) DISCONNECTING/CONNECTING THE MKIV JOYSTICK (FIGURE 2) REPOSITIONING THE MKIV JOYSTICK P TRANSPORTPROCEDURE 11 TRANSPORTING THE WHEELCHAIR (FIGURES 1 AND 2) Page SAFETY FLAG (FIGURE 2) CRUTCH/CANE HOLDER (FIGURE 1) OPTIONSPROCEDURE 12 P Page NOTES LIMITED WARRANTY WARRANTY Y