SECTION
SECTION 2—ASSEMBLY
Unpacking the Patient Lift
Unpack the components from the shipping carton.
Assembling the Patient Lift
WARNING
Use only Invacare parts in the assembly of this patient lift. The base legs, the mast, boom, pump assembly and swivel bar are manufactured to specifications that assure correct alignment of all parts for safe functional operation.
Assembling the Mast Assembly to the Base
NOTE: The mast assembly may be removed from the base for storage or transporting. The mast assembly MUST be properly secured to the base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1.Put the base on the floor.
NOTE: Make sure all four casters make contact with the floor.
2.Lock both rear casters. Refer to Detail “A”.
3.Remove the hex bolt, washers and nut that are located in the U‐shape cut‐out of the base.
4.Lift the mast to an upright position.
5.Lower the mast onto the mounting bracket.
6.Attach the mast to the base with the hex bolt, washers and nut. Tighten securely.
Prepare Lift for Use
Check and tighten all hardware BEFORE use.
Install the Shifter Handle
NOTE: For this procedure, refer to FIGURE 2.2.
1.Remove the shifter handle from the packaging carton.
2.Thread the shifter handle onto the male adapter on the base.
DETAIL “A” Step Here | Step Here |
| |||||||||||||||||||
|
|
|
|
| to Lock | to Unlock |
| ||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Locking
Lever
UNLOCKED LOCKED
|
| Hex Bolt |
Nut | Washer | Washer |
| ||
|
|
Mounting Bracket
FIGURE 2.1 Assembling the Mast Assembly to the Base
Shifter Handle
Male Adapter
in Base
FIGURE 2.2 Install the Shifter Handle
Stand Up Patient Lift | 10 | Part No. 1078984 |
