Replacing the Electric Actuator | Invacare RPS350-1 specs

SECTION 7—MAINTENANCE

Replacing the Electric Actuator

1.Remove the bottom nut, washer and shoulder bolt that secure the electric actuator to the mast mounting bracket.

2.Rest the lift arm on your shoulder and remove the top nut, bolt, bracket and bushing from the lift arm mounting bracket.

3.Remove the electric actuator.

4.Reverse STEPS 1‐3 to install the new electric actuator.

WARNING

DO NOT overtighten mounting hardware. This will damage mounting brackets.

Bracket

Bolt

Bolt

Washer

Washer Bushing

Bolt

Bolt

Washer

Washer Bushing

FIGURE 7.3 Replacing the Electric Actuator

Part No. 1078984

23

Stand Up Patient Lift

Image 23

Invacare RPS350-1 user manual Replacing the Electric Actuator

Contents

Stand Up Patient Lift RPS350-1 Symbol Legend Accessories Warning Table of Contents Limited Warranty Special Notes Label Location RPS350-1 Stand Up Patient Lift Product Parameters Assembling the Lift Weight LimitationUsing the Sling General Guidelines Transferring the Patient Performing MaintenanceOperating the Lift Lifting the Patient Assembling the Patient Lift AssemblyInstall the Shifter Handle Unpacking the Patient Lift May occur Attaching the Battery Charger Mounting Bracket to the Wall Raising/Lowering the Patient Lift Using the Emergency StopOperation Locking/Unlocking the Rear Casters Activating a Mechanical Emergency Release Charging the Battery Positioning the Stand Up Lift Lifting the Patient Lifting the Patient Lifting the Patient Moving the Patient Transferring the Patient Transferring to a Commode Chair Transferring to a Commode Chair Transferring to a Bed Transferring to a Wheelchair Symptoms Faults Solution Troubleshooting Detecting Wear and Damage MaintenanceMaintenance Safety Inspection Checklist Cleaning the Sling and the Lift Lubricating the Lift Adjusting the BaseAdjusting the Knee Pad Height Replacing the Electric Actuator Replacing the Electric Actuator USA Limited Warranty