Troubleshooting, Symptoms Faults Solution

SECTION 6—TROUBLESHOOTING

SYMPTOMS

Noisy or dry sound from pivots.	Needs lubrication.	Refer to Lubricating the Lift on page 22.

Electric actuator fails to lift when button is	Hand-control or actuator	Check the hand control and actuator con-
pressed.	connector loose.	nections. Re-connect as necessary.
	Battery low.	Charge batteries. Refer to Charging the Bat-
		tery on page 13.
	RED emergency stop button	Rotate RED emergency stop button
	pressed IN.	CLOCKWISE until it pops out.
	Battery not connected properly	Reconnect the battery to the control box.
	to control box.	Refer to Charging the Battery on page 13.
	The connecting terminals are	Replace the battery pack. Refer to Charging
	damaged.	the Battery on page 13.
	Electric actuator in need of ser-	Refer to Adjusting the Base on page 22.
	vice or load is too high.	Contact Dealer if service is required.

Unusual noise from actuator.	Actuator is worn or damaged	Replace the actuator or contact Dealer.
	or spindle is bent.	Refer to Replacing the Electric Actuator on
		page 23.

Lift arms will not lower from the uppermost	Lift arms require a minimum	Pull down slightly on the lift arms.
position.	weight load to lower from the
	uppermost position.

NOTE: If problems are not remedied by the suggested means, please contact your dealer or Invacare.

Stand Up Patient Lift

Part No. 1078984