Invacare Top End Terminator Jr manual ADJUSTING/REPLACING Rigid, Tubular Footrest Figure

FOOTREST/ANTI-TIPPER		PROCEDURE 8
ADJUSTING/REPLACING RIGID	5.	Ensure the push pins are fully engaged in the
TUBULAR FOOTREST (FIGURE 2)		mounting holes of the anti-tipper socket.
	6.	Repeat STEPS 1-5 for the opposite anti-tipper if
1. Loosen the two (2) Allen Screws that secure the
		necessary.

footrest to the wheelchair frame.

If Replacing the Footrest:

1. Remove EXISTING and install NEW footrest.

WARNING

The standard footrest has an open hoop. A footplate cover is recommended for wheelchair users that have leg spasticity or whose feet have a possibility of falling through the footrest hoop. A calf strap is provided with each wheelchair to prevent the feet from slipping backwards off of the footrest. Be sure the calf strap is secure when using the wheelchair.

If Replacing or Adjusting the Footrest:

1.Position NEW/EXISTING footrest to desired height.

2.Tighten the two (2) Allen Screws that secure the footrest to the wheelchair frame.

Allen Wheelchair

ScrewsFrame

Adjustment

NOTE: If the rear wheel size is changed or the position of the adjustable axle camber bar is changed, the anti-tip- pers MUST be readjusted to maintain a 1-1/2 to 2-inch clearance between the bottom of anti-tipper wheels and floor.

1.Press the push pin securing the anti-tipper exten- sion to the anti-tipper bar.

2.Position the anti-tipper extension to one (1) of four (4) mounting holes which allow a 1-1/2 to 2-inch clear- ance of the wheels to the floor.

NOTE: A 1-1/2 to 2-inch clearance between the bot- tom of the anti-tipper wheels and the floor must be maintained.

8.Ensure the push pin is fully engaged in the anti- tipper extension mounting hole.

9.Repeat procedure for opposite anti-tipper if nec- essary.

F O O T R E S T

Footrest

FIGURE 2 - ADJUSTING/REPLACING STANDARD

FOOTREST

DETAIL "A" - ANTI-TIPPER

ADJUSTMENT HOLES

A N T I

ANTI-TIPPER REPLACEMENT/ ADJUSTMENT (FIGURE 3)

Release

Anti-tipper

Bar

Camber Mounting

T

I

P P

Replacement

1.Press in the two (2) push pins that secure the EXIST- ING anti-tipper bar to the anti-tipper socket.

2.Remove the anti-tipper bar from the anti-tipper socket.

Buttons

Anti-tipper

Extension

Clamp Hole

E R

4.Insert the NEW anti-tipper bar into the anti-tipper socket.

Anti-tipper Socket

1-1/2 to 2-inch clearance

FIGURE 3 - ANTI-TIPPER ADJUSTMENT/REPLACEMENT

39