Manuals / IPSO / Lawn and Garden / Blower

IPSO T45, T30 installation manual Gas Connection Locations

Models: T30 T45

1 21

Download 21 pages 17.62 Kb

Page 8

Gas Connection Locations

Tumblers – T30 and T45

Gas Connection Locations

C

1	B
	A

11/2 in. NPT

TMB1970N

TMB1970N

	Models			Gas Connection
	Models		A	B	C
			A	B	C
		Non-CE and	75.20 in.	1.74 in.	36.84 in.
T30		Non-Australian	(1910 mm)	(44 mm)	(936 mm)

		CE and	75.28 in.	2.5 in.	30.60 in.
		CE and	75.28 in.	2.5 in.	30.60 in.
		Australian	(1912 mm)	(64 mm)	(777 mm)
		T45	78.75 in.	4.12 in.	42.88 in.
		T45	(2000 mm)	(105 mm)	(1089 mm)
			(2000 mm)	(105 mm)	(1089 mm)

7

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

4-08-43

Image 8

IPSO T45, T30 installation manual Gas Connection Locations

Contents

On-Premise Laundry Planning Handbook T30 and T45 TumblersT477C T477CTable of Contents Model Identification Tumblers - T30 and T45Introduction 1 Serial Plate TMB1974NSpecifications and Dimensions with both pockets running for each pocket N/A = Not ApplicableCabinet Dimensions Exhaust Outlet Locations TMB1969NGas Connection Locations Electrical Connection Locations TMB1971NSteam Connection Locations NOTE All connections use 3/4 inch NPT pipeInstallation Pre-Installation InspectionNOTE Shaded areas indicate adjacent structure Exhaust Requirements LayoutMake-Up Air VentingIndividual Venting NOTE Static back pressure must be measured with both pockets runningEquivalent Length = 14 feet + 2 90 elbows = 14 feet + 14 feet + 14 feet = 42 feet 12.8 mManifold Venting T438I TMB2019N TMB2018N Outlet Duct Diameter45 Typical Electrical Requirements for Gas and Steam Models Refer to Table 4 and TableFor T30 Gas and Steam Models For Total Machine NOTE Use copper conductors onlyFor T45 Gas Models For Total Machine Electrical Requirements for Electric Models Refer to Table