TOWERS AND DOORS INSTALLATION

STEP 12

Move the door assembly to the door post on water tower and slide the assembly into the door post. Locate the base of the door into the slot of serrated door positioner that positions the hinge barrel as shown.

WATER TOWER DOOR POST

GLASS DOOR

BOTTOM OF

DOOR FRAME

STEP 13

Check that the magnetic mouldings on door and air tower overlap. Insert adjusting bolt with locking nut into fixed nut in top cap (See below). Adjust the door with adjusting screw until the glass is parallel with shower base and door moulding mates with water tower mould- ing. It may be necessary to reposition the door into another slot (See STEP 12) which can be done without removing door from wall post. To do so remove the adjusting screw from wall post, lift the door slightly to reposition. Reinsert adjusting screw and locking nut and adjust glass door. After final adjustment, lock this position with locking nut. Repeat for other door.

SHOWER BASE

DOOR POST

ADJUSTING

SCREW (12mm)

HINGE BARREL

LOCKING

NUT

HINGE

BARREL

STEP 14

Install cover cap by sliding over adjusting screw and bracket.

COVER CAP

NOTE: For 3 WALL installation continue with STEP 21 on page 16.

13

Jacuzzi Whirlpool Bath© BZ00000 03/05

Page 15
Image 15
Jacuzzi BZ00000 operating instructions Shower Base