Jacuzzi BZ00000 operating instructions Specifications, Dimensions, Total WEIGHT/FLOOR Loading

SPECIFICATIONS

Important: Read complete instructions before beginning installation.

Each unit arrives ready for installation, equipped with base, glass and associated hardware.

Remove the unit from the carton. Retain the shipping carton until satisfactory inspection of the product has been made.

Immediately upon receipt, inspect the base and other components before installing. Confirm your unit matches your installation rough-in. Check all carton inserts for parts and hardware. Should inspection reveal any damage or defect in any component, do not install the unit. Damage or defect to any component claimed after the unit is installed is excluded from the warranty. Jacuzzi Whirlpool Bath's responsibility for shipping damage ceases upon delivery of the products in good order to the carrier. Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the published warranty information packed with the product.

Jacuzzi Whirlpool Bath© is not responsible for any defect that could have been discovered, repaired, or avoided by following this inspection.

BASE SPECIFICATIONS

Shown is 2 wall left hand base. Right hand opposite. The 3 wall base has tile flange on both sides and back.

DIMENSIONS

72"

	27-11/16"
	1/2" FLEXIBLE
	WATER SUPPLY
48"	HOSES UNDER
	BASE
	(BOTH SIDES)
	AIR SUPPLY HOSE

						TOP VIEW
							30-1/4"
						1-1/2" TILE FLANGE
21-1	/		16"				27-1/4"	6-1/2"
		18-1		1	/16"
									4-1/2"
							FRONT VIEW
PRODUCT WEIGHT (Base and Enclosure )							TOTAL WEIGHT/FLOOR LOADING
950 lb							1266.6 lb	(574.5 kg)
(431 kg)							63.3 lb/sq. ft.	(332.1 kg/m2)

NOTE: MINIMUM WATER PRESSURE FOR THE SYSTEM IS 45 PSI WITH 3/4" HOT & COLD SUPPLY SERVICE.

2

Jacuzzi Whirlpool Bath© BZ00000 03/05