Luxury Whirlpool Bath
RapidHeat™
The heater turns ON automatically any time whirlpool operation is active. Heater operation is not displayed on the control panel. There is a visible indicator light on the heater itself that signifies the heater is operating. The heater will help maintain the temperature of the water in the bathtub.
Vacuum Switch
The heater is equipped with a preset vacuum switch which will not allow the heater to turn ON if the pump is not running and water is not flowing through the whirlpool system.
English
High-Limit Switch
The heater includes an exclusive
OVER HEAT
PROTECTION
PUSH TO RESET
High Limit
Reset
HEATER ON
Heater On
Purging the Whirlpool System
To remove accumulations of bathtub residue from the whirlpool system, it is recommended that a whirlpool bathtub be cleaned at least twice a month. For best results, however, we recommend that you clean your whirlpool bathtub after each use using, Systems Clean™, our exclusive
Bathtub Additives
Do not use oil or
If you want to use any kind of bathtub additive, use only a small amount of
The use of certain bathtub oils, bubble baths, and bathtub additives may increase the level of accumulations of bathtub residue in the whirlpool system and may cause false reading of the water level sensors. If excess accumulations persist, you should discontinue use of these products.
Installation and Operation | www.jacuzzi.com | Page 19 |
