Brocade Communications Systems 6910 manual Traps and Objects to Enable Traps, Trap information

	Chapter
Traps and Objects to Enable Traps	13

Objects for Brocade 6910 switch traps

This section present the objects available to enable or disable traps.

Trap information

The following objects provide general information on traps.

Name, OID, and Syntax	Access	Description
snAgTrpRcvrCurEntry	Read only	Shows the total number of entries that are currently in the Trap
brcdIp.1.1.2.1.16		Receiver Table. There can be up to 5 entries.
Syntax: Integer

Trap receiver table

This table allows you to configure trap receivers on the Brocade 6910 switch:

Name, OID, and Syntax	Access	Description
fdryTrapReceiverTable	None	The Trap Receiver Table.
brcdIp.1.1.10.1.1.1
fdryTrapReceiverEntry	None	An entry in the Trap Receiver Table. This table uses a running
brcdIp.1.1.10.1.1.1.1		index as the index to the table.
		Reasons to use the running index scheme rather than IP
		addresses:
		1	The table will be Virtual Routing and Forwarding (VRF)
			independent so that multiple VRFs can share the same
			address type and address.
		2	An index with address type and address could be
			potentially 17 unsigned integers, causing parsing and
			finding the next index to take much CPU time. The PDU
			gets to be huge too.
		3	An IP address is just another attribute, and they are
			supposed to be a list of servers.
fdryTrapReceiverIndex	None	The index to the Trap Receiver Table.
brcdIp.1.1.10.1.1.1.1.1
Syntax: Unsigned32
fdryTrapReceiverAddrType	Read-create	Trap Receiver IP address Type. Supported address types are:
brcdIp.1.1.10.1.1.1.1.2		•	ipv4(1)
Syntax: InetAddressType		•	ipv6(2)
		•	ipv6z(4)

Default: ipv4

Brocade 6910 Ethernet Access Switch MIB Reference	57
53-1002582-01