Brocade Communications Systems 6910 manual Software configuration, Switch IP configurations

Software configuration

Software configuration

Switch IP configurations

Name, Identifier, and Syntax	Access	Description
snAgGblIfIpAddr	Read-write	Shows the IP address of the interface.
brcdIp.1.1.2.1.13
Syntax: Integer
snAgGblIfIpMask	Read-write	Shows the IP address mask of the interface.
brcdIp.1.1.2.1.14
Syntax: Integer
snAgDefGwayIp	Read-write	Shows the IP address of the default gateway router.
brcdIp.1.1.2.1.10
Syntax: Integer

SNTP server table

These objects provide information on the SNTP server.

NOTE

In a specific configuration and with IPv4 SNTP servers only, SNMP may stop working when the SNTP server table is viewed. If this occurs, add rfc4001-inetAddressMIB.mib or rfc4001.mib.

Name, Identifier, and Syntax	Access	Description
fdrySntpServerTable	None	Simple Network Time Protocol (SNTP) server table.
brcdIp.1.1.7.1.1.1
fdrySntpServerEntry	None	An entry in the SNTP server table. This table uses running index as
brcdIp.1.1.7.1.1.1.1		the Index to the table.Reasons to go for running index Scheme
		rather than IP addresses:
		1	The table will be Virtual Routing and Forwarding (VRF)
			independent so that multiple VRFs can share the same
			address type and address.
		2	Index with address type and address could be potentially 17
			unsigned integer, dp parsing and finding the next index takes
			CPU time. The PDU gets to be huge too!
		3	IP address is just another attribute; they are supposed to be
			a list of servers.
fdrySntpServerIndex	None	The index to the SNTP server table. A maximum of three SNTP
brcdIp.1.1.7.1.1.1.1.1		servers are supported.
Syntax: Unsigned32
fdrySntpServerAddrType	Read-create	The SNTP server IP address type:
brcdIp.1.1.7.1.1.1.1.2		•	ipv4(1)
Syntax: InetAddressType		•	ipv6(2)
		•	ipv6z(4)

Default: IPv4

28	Brocade 6910 Ethernet Access Switch MIB Reference
	53-1002582-01