Jacuzzi K339000X manual Installation Instructions, Begin Installation

INSTALLATION INSTRUCTIONS

Installation	See END/SIDE VIEW in
Note that the motor/pump protrudes beyond the bath rim a maxi-	Specification pages for
mum distance of 1" (25,4 mm). Care should be used when lowering	this dimension.
the tub into cutout to prevent injury to installer(s), finished surfaces,	(Heater)
or tub and components.
Clearance must be provided for installers. See page 16 for	(Motor)
recommended clearances surrounding tub. Damage to shell,
plumbing, wiring, lighting, and other components because of
failure to observe minimum clearances are not the responsibility
of Jacuzzi Whirlpool Bath.

All deck finish work must be completed before installation. Use the Cutout Template provided. Flooring surface inside the cutout to deck height must not exceed height specification for tub.

Cover all finished surfaces to protect from damage during tub installation. Turn OFF power supply to dedicated GFCI protected circuits.

ENGLISH

Begin Installation

Optionally, use a washable marker to scribe a reference line 1" (25,4 mm) out- side the cutout edge on the deck surface. This may assist in final alignment of the tub.

Install any trim kits, faucets, or other tub components before installing.

TUB

CUTOUT

REFERENCE
LINE	1/2"

To install unit insert the motor/pump end first when lowering the tub into the cutout opening as shown in the bottom illustration. Do not use plumbing fixtures or plumbing lines to lower unit. The clearance under the substrate is required for air flow circulation requirements.

Place a piece of scrap lumber under each corner as a temporary support for the tub rim. Inspect all fittings, plumbing, and control lines after inserting to insure components are not damaged, disconnected, or contacting the finish surface substrate or

support members.			FINISHED SURFACE
Connect flex water supply lines to faucet.
		2 " MAX	SCRAP LUMBER
Plug power cords into GFCI outlet.
		THICKNESS
Remove fingers, hands, and all other items from under the rim edge before lowering the tub.
Slightly lift one tub end and remove the scrap lumber. Gently lower the tub rim until it contacts the	APPROX. 2-1/2"
deck surface. Slightly lift the remaining tub end and remove the scrap lumber. Gently lower the			SUBSTRATE
tub rim until it contacts the deck surface.
If you created the optional reference lines, align the tub over the cutout.
Connect drain line.
Turn ON the power supply to the dedicated GFCI protected circuits.	SUBFLOOR	SUPPORT
Check for leaks and check system operation.

		** MIN CLEARANCE - DUETTA 3"-3½"
		TILE OR FINISHED
		SURFACE
TILE OR		SUBSTRATE
FINISHED
SURFACE
		TYP MIN. 1-1/2"
		CLEARANCE**
SUBSTRATE
SUPPORT	SUBFLOOR	SUPPORT
MEMBER		MEMBER
	17

Jacuzzi Whirlpool Bath K339000X 3/06