JAI CV-A1 operation manual Pin Assignment, Pin Multi-connector DC-IN/VIDEO OUT, EXT.HD/VD

CV-A1

5. Pin Assignment

5.1.12-pin Multi-connector (DC-IN/VIDEO OUT, EXT.HD/VD IN)

Type: HR10A-10R-12PB-01 (Hirose) male

		Seen from rear			Pin configuration is compatible with EIAJ standard
					Pin no.	Signal	Remarks
					1	GND
		1	9		2	+12 V DC input
					3	GND
	2	10		8
					4	Video output	Parallel with the BNC connector.
3		11	12	7
					5	GND
		4		6
					6	HD input/HD output	*)	SW2.1 on for 75Ω. SW1.1 on for HD out.
		5
					7	VD input/VD output	*)	SW2.2 on for75Ω. SW1.2 on for VD out.
					8	GND
					9	Pixel clock output	*)	JP2 short and PC=1 for pclk out.
					10	WEN output	*)	GND if JP5 open and JP3 short
					11	Trigger input	*)	+12V DC if JP1 short and JP4 open
					12	GND

Fig. 2. 12-pin connector.

Plugs for cable: HR10A-10P-12S

5.2.6-pin Multi-connector (TRIGGER)

Type: HR10A-7R-6PB (Hirose) male

Seen from rear.

		Pin no.	Signal	Remarks
		1	TXD out
1	6	2	RXD in
2	5	3	GND
3	4	4	GND
		5	Trigger input	*)	Parallel with pin 11 on 12 pin con
		6	EEN output	*)	*2). WEN output if EW=1

Fig. 3. 6-pin connector.

Notes.	Plugs for cable: HR10A-7P-6S
*)	Alternative signals can be placed on these pins by switch or jumper settings or
	RS-232C commands.
	Configurations shown in Bold + italic is factory setting.
*2)	EEN will be low all the time in normal continous mode (TR=0), if the selected
	exposure time is longer than the frame readout time.

- 4 -