JP10JP12 | JAI CV-M300 specs

7.4.2. Board PK8042 Side A

7.4.1. Board PK8041 Side A

CV-M300

7.4. Location of SW2 and JumpersJP8JP9SW2JP7

Jumpers are shorted with a 0 Ohm resistor or by a soldering between the 2 points. To remove the solder tin from a jumper position, use a special tin remover such as de-soldering wick.

JP10JP12

JP14

- 17 -

Image 18

JAI CV-M300 operation manual JP10JP12

Contents

CV-M300 Declaration of Conformity Table of Contents Standard Composition Main Features General Locations and Functions Pin Multi-connector DC-IN/SYNC Pin Multi-connector TriggerPin Assignment External Trigger Mode Input/Output of HD/VD SignalNormal Shutter Mode Functions and Operations EIA Non-interlaced / Field accumulation mode =4.4∝ S Ccir Non-interlaced / Field accumulation mode Pulse Width Control Mode Pulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M300 Long Time Exposure Mode EIA Ccir CV-M300 Table for SW 1 Setting Mode Setting1. SW1 Switch on the Rear Panel OFF = On = SW2 on PK8041 Board Jumper Settings Pixel Clock Output JP10JP12 Adjustment of Video Signal Output Level External Appearance Tripod mount plate Specifications Spectral Sensitivity Precautions Typical CCD CharacteristicsAppendix Camera type CV-M300 Scanning system Users Mode Settings Users ModificationsUser’s Record Revision Revision E Serial No 2700-11088E E1