JAI CV-M91 Pin Assignment, Pin Multi-connector DC-IN/Trigger, Pin no Signal Remarks

CV-M91

5. Pin Assignment

5.1. 12-pin Multi-connector (DC-IN/Trigger)

Type: HR10A-10R-12PB-01(Hirose) male.				Pin no.	Signal	Remarks
Plugs for cable: HR10A-10P-12S				1	GND
(Seen from rear of camera.)				2	+12 V DC input
				3	N/C
				4	NC/VBS video out	*), VBS 75 Ω source
				5		SW604-1 on for VBS out
	1	9			GND
2	10		8	6	HD in/HD out	75 Ω term. By SW301-1
3	11	12	7	7		*), HD out 75 Ω source
					VS in/VD in/VD out	75 Ω term. By SW301-2
	4		6
						*), VD out 75 Ω source
	5			8	GND
				9	NC/Pixel clock out	*), 75 Ω source
				10	GND
Fig. 2. 12-pin connector.				11	+12 V DC input
				12	GND

Notes:

Factory setting in bold italic.

*) Alternative signal by internal switch/jumper Refer to “7. Configuring the Camera.”

5.2. 6-pin Multi-connector (TRIGGER and RS232C)

Type: HR10A-7R-6PB (Hirose) male

Plugs for cable: HR10A-7P-6S

Seen from rear.

		Pin no.	Signal	Remarks
		1	TXD out	RS-232C
1	6	2	RXD in	RS-232C
2	5	3	GND
3	4	4	EEN output	75	Ω source
		5	Trigger input	75	Ω termination by int. switch SW301-3
		6	WEN output	75	Ω source

Fig. 3. 6-pin connector.

Notes:

Refer to “7. Configuring the Camera.”

EEN (Exposure Enable) pulse indicates the duration of the shutter, and can be used for controlling strobe illumination.

EEN will be low all the time in normal continous mode if the shutter is off.

WEN (Write Enable) pulse indicates the period of effective video signal output. It is usefull for setting the timing with framegrabber.

For schematic diagram of the input and output circuit with alternative settings refer to 5.3.

- 4 -