z
x
c
v
Inserting the bobbin
z Press the lockout key.
Place a bobbin in the bob bin holder with the thread
running off counterclockwise as shown on the hoo k
cover plate.
q Lockout key
w End of thread
e Bobbin holder
r Hook cover plate
x Hold the bobbin with your fingertip so it does not
rotate.
Guide the thread into the front notch of the b obbin
hol der.
Pull the thread to the left to pass it und er the guide.
t Front no tch
y Guide
c Draw the thread to the left to pas s it into the guide
path marked “1”.
Make sure that the thread comes out from the sid e
notch of the bobbin holder.
u Guide path 1
i Side notch
NOTE:
If the thread does not come out from the side notch,
rethread from step z.
v Continue to draw the thread along the guide path
marked “2” and pull the thread to the right through the
slit. The thread will be cut to a proper length and held
in place.
o Guide path 2
! 0 Slit (Thread cutter)
ew
r
t
y
u
Correct
i
ii
Wrong
o
!0
b
r
b Set the left ed ge of the hook cover plate into opening.
Push down the hook cover plate to fit in place.
NOTE:
Unless otherwise noted, you can start sewing withou t
drawing up the bobbin thread.
Refer to page 17 for how to draw up the bobbin
thread.
q
14