Janome JP760 manual Threading for bobbin winding, Additional spool pin

z q

x

c

v

Threading for bobbin winding

Set the speed control lever at .

zHold the thread with both hands and pass the thread under the thread guide.

q Thread guide

w

xDraw the thread toward you and guide the thread

around the bobbin winding thread guide. w Bobbin winding thread guide

cPass the thread through the hole in the bobbin from the inside to the outside. Put the bobbin on the bobbin winder spindle.

v Push the bobbin winder spindle to the right.

The indicator will show .

b

	b Hold the free end of the thread in your hand and
	start the machine.
	Stop the machine when the bobbin has been
	wound a few layers, and cut the thread close to
	the bobbin.
n	n Start the machine again. When the bobbin
	is fully wound, it will stop automatically.
	Stop the machine and return the bobbin
	winder spindle to its original position by moving it
	to the left, and cut the thread with a pair of
	scissors. Remove the bobbin from the bobbin
	winder spindle.
	NOTE:
	The machine will not sew until the spindle has been
	returned to the left.
	Additional spool pin
	The additional spool pin is for bobbin winding without
	unthreading the machine.
w	Insert the additional spool pin into the hole.
	Place the felt and a spool on the pin.
q
	q Additional spool pin
e
	w Spool pin felt
	e Spool pin hole

12