Janome JP760 manual To sew

z

q

w

x

e

r

To sew

zPress the up/down needle button to raise the needle.

Attach the automatic buttonhole foot R snapping the pin into the groove of the foot holder.

q Groove w Pin

xPull the button holder to the back, and place the button in it. Push it together tightly to the button.

NOTE:

If the button is extremely thick, make a test buttonhole on an extra piece of the fabric.

If it is difficult to fit the button through the test buttonhole, you can lengthen the buttonhole by pulling the button holder back a little. The length of the buttonhole will be increased.

eButton Holder r Extra gap

c	c Pull the buttonhole lever down as far as it will go.
	t Buttonhole Lever

t

v	i	v Insert the corner of the fabric under the foot.
		Press the up/down needle button twice.
		Remove the fabric to the left to draw the needle
	!0	thread through the hole of the foot.
		Place the garment under the foot, and lower the
		needle at the starting point of the buttonhole
		mark.
	o	Then lower the automatic buttonhole foot R.
		y Buttonhole Mark
		u Starting Point

y

u

!1

NOTE:

Make sure there is no gap between the slider and stopper, otherwise the left and right lengths will be different.

iSlider o Stopper !0No gap !1Sewing gap

24