I N S T A L L A T I O N S / S E T U P
STARTING UP (continued)
Testing the System
At the beginning of or anytime during a system setup, the hookup configuration of the EVO loudspeaker can be tested by using the TEST button.
This button is used to control the user audio test mode, i.e. pressing it will produce ‘pink noise’ output from each EVO loudspeaker.
The first press of the TEST button will…
1.Enable the Test Mode.
2.Illuminate the orange TEST LED.
3.Cause the first found EVO loudspeaker to transmit ‘Pink Noise’.
4.Flash the relevant Speaker Status Green OKAY LED to indicate the Limpet transmitting.
Successive presses of the TEST button will…
1.Move the ‘Pink Noise’ to the next EVO loudspeaker.
2.Indicate the ‘New Transmitting’ EVO loudspeaker by flashing the relevant Speaker Status Green OKAY LED.
When all attached EVO loudspeakers have been tested, the next press of the TEST button will exit Test Mode and extinguish the TEST LED. There is a short delay between pressing the TEST button for the last time and returning all speakers to normal operation.
EQ SELECT | SETTINGS |
| AUTO EQ SETTING |
|
MUSIC I |
|
|
|
|
MUSIC II | LOCKED | EQ SET | EQ SET |
|
SPEECH |
| MAIN OUT | AUX OUT |
|
NEUTRAL | TEST | SETUP 1&2 | SETUP 3&4 | AEQ ON |
|
| HOLD TO CLEAR MAIN HOLD TO CLEAR MAIN |
| |
Figure 9
If the LOCK switch is engaged at any time during Test Mode, Test Mode will immediately end. The TEST indicator LED will be extinguished and any EVO loud- speakers will stop transmitting ‘Pink Noise’.
10
