JBL EVOi.net manual Rear Panel

F E A T U R E S

REAR PANEL

Figure 3

10 11 12 13 14 15

10RU Mounting Holes

The EVOi.net is equipped with four mounting holes for installation in one RU (rack unit) space.

11Power Connector

Insert the enclosed power cord into the IEC connector to supply the specified AC power.

12Fuse

The removable fuse protects internal circuits. When replacing the fuse, be sure to use the same type as speci- fied.

13INTERFACE Connectors

Two 8-pin RJ-45/Shellnet connectors, labeled LINK IN and LINK OUT, will provide interlinking to other EVOi.net units. Functionality will be determined at a later date.

16 17 18 10

15OUTPUTS (4B/3A), Auxiliary

Two 3-pin male XLR connectors for right (4B) and left (3A) connection to auxiliary EVOi.324 loudspeakers using a pair of XLR signal cables.

For mono operation, press MONO SUM to sum the input signals and route the combination to both outputs. The mono signal level will be 4 dB lower than the stereo level.

16OUTPUTS (2B/1A), Main

Two 3-pin male XLR connectors for right (2B) and left (1A) connection to main EVOi.324 loudspeakers using a pair of XLR signal cables.

For mono operation, press MONO SUM to sum the input signals and route the combination to both outputs. The mono signal level will be 4 dB lower than the stereo level.

14Lockout Switch

To protect settings from being inadvertently changed, press this recessed button once to disable TEST, AUTO EQ SETTING, AEQ ON, and DELAY SET and to lock their parameters. The orange LOCKED LED (under SET- TINGS on the front panel) will turn on to confirm the lockout. To restore functionality and to change settings, press this recessed button once again.

17INPUTS (B/A)

Two 3-pin female XLR connectors for right (B) and left (A) connection to the EVOi.sys R MIX OUTPUTS L using a pair of XLR signal cables.

18SETUP MIC

A 3-pin female XLR connector for connection to the enclosed measurement microphone using the supplied 100’ XLR signal cable.

6

EVOi.net