JBL SCS200.6/230 manual Dolby PRO LOGIC* NON-DIGITAL Line Level, Right Front, Right Surround

DOLBY* DIGITAL OR DTS®

(OR OTHER DIGITAL SURROUND MODE) CONNECTION

RECEIVERSUBWOOFER

LFE OUT	LINE LFE	L	R
	LEVEL
	IN

Use this installation method for Dolby* Digital, DTS® or other digital surround processors:

Use the line-level input jack marked “LFE” for the Low- Frequency Effects channel. Connect this jack to the LFE

output or subwoofer output on your receiver or amplifier. Connect each speaker to the corresponding speaker terminals on your receiver or amplifier.

Make sure that you have configured your surround sound processor for “Sub- woofer On”.

For the SCS200.6 system, the receiver should be config- ured for 6.1-channel opera- tion. For both the SCS200.5

and SCS200.6 systems, the front left, front right, center and rear speakers should all be set to “Small.”

If your receiver allows you to set the crossover frequency between the subwoofer and the main speakers, select 120Hz or the setting that is the closest frequency below it.

DOLBY PRO LOGIC* (NON-DIGITAL) – LINE LEVEL

Use this installation method for Dolby Pro Logic* applica- tions (not Dolby Digital, DTS or other digital processing), where the receiver/proces- sor is equipped with a sub- woofer output, or a volume- controlled preamp (line-) level output:

Use RCA-type interconnects to connect the line-level subwoofer outputs on your receiver or amplifier to the line-level inputs on the sub- woofer. IMPORTANT: Do not use the LFE input on the sub- woofer with Dolby Pro Logic processors.

NOTE: If your receiver or amplifier only has one sub- woofer output jack, then you will need to use a Y-connec- tor (not included). Plug the male end of the Y-connector into your receiver or ampli- fier’s subwoofer output jack, and connect each of the two female ends to separate

Left Front			Center			Right Front
–	+		–	+		–	+
			Subwoofer
			Line-
			Level In
			L
			R
			Receiver
	Left		Subwoofer		Right
	Front		Out		Front
	–	+			–	+

R L

–+

		Left	Center		Right
			Surround Back†
	Surround				Surround
	–	+	–	+	–	+
Left Surround			Surround Back†			Right Surround
–	+		–	+		–	+

RCA-type interconnects. Finally, plug the RCA-type interconnects into the line- level inputs on the sub- woofer.

Connect each speaker to the corresponding speaker terminals on your receiver or amplifier.

Make sure your receiver or processor is correctly con- figured to indicate that the subwoofer is “On.”

Note for advanced users: If your receiver/processor has a built-in low-pass crossover filter for the subwoofer out- put, you may use the LFE input to bypass the sub- woofer’s internal crossover.

9